E. CHANGING STONES

The 41/2" and 10" stones can both be removed for re-surfacing or replacement. To change the 41/2" stone:

1.Remove the eye shield and and the outside wheel guard.

2.Turn the shaft nut counterclockwise while holding the stone. Figure 9.

3.Remove the nut, washer and stone.

4.To install a new stone, reverse the above procedure.

Figure 9. Changing the small wheel.

DO NOT make inspections or adjustments while the Slow-Speed Grinder is running. Ensure that the switch is off, power is disconnected and moving parts have stopped before making adjustments. Failure to do so could result in serious injury.

IX. MAINTENANCE (Continued)

To change the 10" stone:

1.Remove the four cap screws which secure the shaft to the reservoir. Figure 10.

2.Slide the outer bearing off the shaft.

3.Loosen the nut and turn it counterclockwise to remove it.

4.Slide the stone off the shaft.

5.Reverse the procedure to install a new stone.

Figure 10. Changing the large wheel.

The 10" grinding stone is quite heavy. Use care when removing it from the grinder.

G1036 Slow-Speed Grinder

-12-