VII. ASSEMBLY

A. EYE SHIELD

Attach the plastic eye shield to its mounting bracket using the 2 Phillips® Head screws and nuts provided, then attach the eye shield assembly to the outside wheel guard just above the cut- away. A knurled knob holds the eye shield in place. Figure 1.

Figure 1. Knob to adjust eye shield.

The Model G1036 Slow-Speed Grinder’s Eye Shield is included for your protection. Failure to attach the Eye Shield could result in serious personal injury to the operator or others in the work area.

B. TOOL RESTS

Attach the tool rest for the 41⁄2'' grinding stone to the inside wheel guard of the G1036, using the knob and Hex Nut supplied. Figure 2. The Hex Nut is placed between the knob and tool rest and acts as a jam nut, preventing the knob from vibrating loose.

Figure 2. Knob to adjust tool rest.

The tool rest for the 10'' stone is attached to the right end of the water reservoir. Bolt the tool rest in place using the 2 Hex Bolts, Nuts and Washers provided. Figure 3. The two lever-type handles are used to adjust the tool rest for the proper positioning relative to the wheel.

Figure 3. Bolts to mount tool rest.

-7-

G1036 Slow-Speed Grinder