-24- Model g1095/g1096 1-hp power Feeder
if you damage one or more wheels or they are
worn out, you can easily replace the wheels.
tools Needed Qty
hex Wrench 5mm ..............................................1
to replace a worn out or damaged wheel:
1. disConnECt thE poWEr FEEdEr
FroM poWEr!
2. using a 5mm hex wrench, remove the wheel
retaining cap screws (Figure 17).
Wheel Replacement
always disconnect power
to th e machin e befo re
performing instal lation
or maintenance. Failure
to do this may result in
serious personal injury.
3. swap the old wheel with the new one.
4. reinstall the four cap screws, and tighten in
an alternating pattern until the wheel is tight.
Figure 17. Wheel cap screws.
Cap
screw