Table Saw Adjustments:
Pinching, binding and blade height are issues of concern when using the power feeder with a table saw. If you are ripping boards 4" or wider, place the power feeder between the fence and blade with the rollers turned slightly toward the fence. If you are ripping materials less than 4", set the rollers as close as possible to the fence. Do not set the rollers so the waste side of your material binds or pinches the blade. The rollers should be angled with no more than 1⁄8" of variation between the leading and trailing wheels.
IMPORTANT: The blade height on your table saw must just slightly exceed the height of your workpiece. Do Not allow the blade to cut into your rollers. Figure 7.
Figure 7.
You may elect to remove the middle wheel to gain even more clearance.
Some fences clamp at the front only. You will need to use an auxiliary clamp for the back of your fence if this is the case. The power feeder will push the fence out of alignment if it is not clamped adequately.
|
|
|
|
|
|
|
|
|
|
|
|
G1128/G1129 Power Feeders | |||
