Disc Sanding
1.Loosen table lock knob and tilt work table to desired angle. Tighten lock knob.
2.Use miter gauge to guide work into position.
3.Ease workpiece into the half of the disc that spins down toward the table. See Figure 17.
Surface Sanding
To remove a large amount of material quickly from a large surface area, use the belt arm in its horizontal position.
1.Turn the sander on and let it reach its full working speed.
2.Place the workpiece flat on the belt. Be sure to hold the work securely with both hands. Place one hand at the end of the workpiece to feed it against the rotation of the belt. Place the other hand lightly on top of the workpiece to ensure adequate stock removal. See Figure 18.
Figure 17. Disc sanding.
Figure 18. Surface sanding.
Operating this equipment has the potential to propel debris into the air which can cause eye injury. Always wear safety glass- es or goggles when operating equipment. Everyday glasses or reading glasses only have impact resistant lenses, they are not safety glasses. Be certain the safety glass- es you wear meet the appropriate stan- dards of the American National Standards Institute (ANSI).
G1183/1276 Combination Sander |
