Grizzly G3105 instruction manual Assembly, Overview

SECTION 4: ASSEMBLY

Overview

Most of your G3105 Belt and Disc Sander has been assembled at the factory. The few pieces that remain should go together quickly and easi- ly. Only a few common tools are required to assemble your Combination Sander. Specifically, these are: 12mm open end wrench, Phillips® head screwdriver, 8mm Allen® wrench (provided with machine). The following list provides the rec- ommended order in which the sander should be assembled:

•Outside Belt Guard

•Belt Table

•Disc Table Bracket

•Disc Table

Before beginning the assembly process, we rec- ommend you become familiar with the Model G3105 Combination Sander’s parts and controls. See Figure 2 below, as well as the Parts Diagram at the end of the manual for details.

All die-cut metal parts have a sharp edge (called “flashing”) on them after they are formed. This is generally removed at the factory. Sometimes a bit of flashing might escape inspection, and the sharp edge may cause cuts or lacerations when handled. Please examine the edges of all die-cut metal parts and file or sand the edge to remove the flashing before handling.

SANDING DISC

MITER GAUGE

DISC TABLE

TABLE TRUNNION

TRACKING SCREW

TENSION KNOB

GUARD MOUNTING KNOB

MOTOR BODY

BELT TABLE

BELT TABLE ADJUSTMENT SCREW

HORIZONTAL ADJUSTMENT SCREW

ANGLE GUIDE SCREW

SWITCH

Figure 2. Major components of the G3105.

G3105 Combination Sander -9-