Outside Belt Guard |
| Belt Table |
|
|
|
|
|
|
Using two of the knobs provided, mount the out- side belt guard to the
Guard
Mounting
Holes
Figure 3. Outside belt guard attachment points.
Use the 3/8" - 16 x 3/4" cap screw and 3/8" washer to secure the table to the inner belt guard. The slotted bracket is provided to enable maximum adjustment. See Figure 4. Use a machinist’s square to set the table to 90˚ to the face of the sanding belt. The table can also be tilted down an additional 45˚. Simply loosen the cap screw and adjust to the desired angle.
Belt Table
Adj Cap Screw
Figure 4. Belt table properly mounted.
DO NOT attempt to turn on the machine during any step of the assembly process, unless instructed otherwise. Make sure the power switch is in the OFF position and the plug is disconnected from its power source during assembly. Failure to do so could result in injury or electrical shock.
G3105 Combination Sander |
