Chuck Extender
The use of the chuck extender is only necessary if the chisel is too short to reach the chuck. The extender will lower the chuck approximately 1''. To install the extender:
1.Remove the chuck cover on the mortiser’s head by loosening the knobs at the front and side of the cover plate.
2.Hold the motor shaft in place with a 10mm wrench. Insert a phillips screwdriver into the chuck key hole and unscrew the chuck in a clockwise direction. Figure 10.
Figure 10.
3.Thread the chuck extender onto the end of the motor shaft then thread the chuck on.
4.Lightly tighten the chuck onto the extender.
|
|
|
|
|
|
|
|
|
|
|
|
G3183 Hollow Chisel Mortiser | |||
