MODEL G5344 |
AIR PALM SANDER |
INSTRUCTION SHEET |
EYE INJURY HAZARD!
Always wear safety glasses when using this tool to prevent serious personal injury.
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected 
operation during service.
DUST HAZARD!
Always wear respirator when
using this tool.
Introduction
This 15,000 RPM air sander requires 75 PSI and 3" x 41/2" sanding sheets. (You can cut a standard 9" x 11" sanding sheet into sixths and trim each piece to size.) Air hose inlet is 1/4" NPT.
Inventory |
| |
A. | Air Palm Sander | ......................................... 1 |
B. | Air Hose | 1 |
|
| B |
| A |
|
Assembly and Attaching Abrasives
To assemble the sander and attach sandpa- per:
1.Thread the air hose into the sander.
2.Install a 1⁄4" NPT male
3.Lift one clamp up over the bracket (Figure 2), then pull the clamp down to open it.
Bracket
Figure 2. Opening clamp.
4.Insert one end of the sandpaper between the clamp and base as shown in Figure 3, and lift the clamp up and back over the bracket to secure the sandpaper.
Figure 1. Model G5344.
Figure 3. Attaching and securing sanding sheet.
COPYRIGHT © MAY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#BL8253 PRINTED IN TAIWAN
