OPERATION
Loading Nailer
To load your nailer:
1.Disconnect the air supply from the nailer!
2.Load nails at the top of the magazine in the
Figure 1. Loading the nailer (side view and end view). Match nail heads with head slot for insertion.
3.Slide the stick of nails all the way down to the nose of the nailer.
4.Pull the magazine pusher all the way back, then let it come forward until it catches on the end of the nail stick.
When replacing nails for your Model G6049, follow these guidelines:
Gauge: 14/15
Length:
Capacity: 100 Nails
Single/Bump Fire Mode
The Model G6049 is equipped with a sin- gle/bump fire trigger.
To select single or bump fire operation:
1.Disconnect the air supply from the nailer!
2.Locate the hex nut that secures the safety yoke mechanism to the trigger housing. See Figure 2.
3.To select Single Fire mode, tighten the hex nut completely.
4.To select Bump Fire mode, unthread the hex nut at least two full turns.
Adjustment |
Hex Nut |
Figure 2. Single/bump fire adjustment.
G6049 14/15 Gauge Angle Finish Nailer Kit |
