![](/images/new-backgrounds/1209948/20994821x1.webp)
SECTION 4: ASSEMBLY
Water Reservoir
Insert the water valve into the hole in the Water Reservoir. Attach the Water Reservoir to the post behind the wet grinding wheel. Position the water drip over the center of the grinding surface.
Attach the clear plastic drain pipe to the fitting which in on the underside of the wet wheel hous- ing.
Water Valve
Mounting Post
Drain Pipe
Figure 2. Mounting water reservoir.
Tool Rest/Eye Shield
The Tool Rest attaches to the front of the dry grinding wheel. It is adjustable for height and for angle to provide a steady platform for a variety of grinding angles and sizes. Refer to Figure 3 for general orientation of the Tool Rest and Eye Shield.
To assemble the Tool Rest:
1.Take the
2.Secure the bracket to the rest with two (2) hex head bolts and the wing nuts which have a plastic knob.
3.Attach the assembled Tool Rest to the Wheel Guard using a hex head bolt and washer.
Figure 3. Dry wheel guard and rest positioning.
To assemble the Eye Shield:
1. Take the
2.Use the two (2) combination head screws, washers and nuts to secure the
3.Attach the assembled Eye Shield to the right side of the wheel guard using the short hex head bolt and washer.
|
|
|
|
|
|
|
|
|
|
|
|
G8220 Wet/Dry Bench Grinder |