OPERATION, CONT’D
The potential for injury using this device is great. Use extreme caution and care when operating, adjusting and maintaining this saw. Failure to observe safe handling practices will result in serious personal injury.
Inserting Battery Into Trim Saw
1.Insert the battery into the handle of the trim saw so that the long end is forward. The battery will only install in one orientation.
2.Make sure the securing clasps on either side of the trim saw base engage with the clips on the battery compartment.
Operating the Trim Saw:
1.Insure the blade is secure and the battery is installed.
2.Grasp the hand grip with one hand. Use the hand you would use most often: if you are right handed use the right.
3.Grasp the stabilizing hand grip with the other hand.
4.Place the leading edge of the saw on the edge of the board to be cut. Align the guide notch to a reference line or the edge guide to the end of the board.
5.Insure the blade will not contact the board during start up by pulling blade away from the edge of the board.
6.With your middle finger, slide the trig- ger lock back towards the battery.
7.Pull the trigger to activate the trim saw.
8.Slowly feed saw through the cut.
9.Let go of the trigger when finished with the cut.
Avoid kickback hazards! If saw motor stalls during cut release the trigger immediately. Determine the cause of the problem and rectify before continu- ing cut.
Fig 9. Proper Holding Grip.
G8598 51⁄8" Cordless Trim Saw |
