Grizzly G9859 instruction manual Infeed Table, Fence Stop

Infeed Table

To adjust the infeed table:

1.The infeed table can be adjusted the same way as the outfeed table. Loosen the infeed table lock knob in the center of the handwheel.

2.Place a straightedge on the outfeed table so it hangs over the infeed table. Turn the cutter- head so that the knives are NOT touching the straightedge.

3.Loosen the infeed table lock knob. Raise the infeed table until it just touches the straight- edge as shown in Figure 13. Tighten the table lock knob.

4.Adjust the depth of cut scale to read “0”.

Figure 13. Setting the depth of cut scale.

90° Fence Stop

1.Place a square on the outfeed table fairly close to the cutterhead as shown in Figure 14.

Figure 14. Use of square to align fence.

2.While holding the fence adjusting handle, loosen the angle setting lock knob and the checknut on the 90° stop screw as shown in Figure 15. Turn the stop screw against the sliding bracket until the fence contacts the edge of the square evenly.

3.Tighten the checknut on the stop screw and tilt the fence back, then forward against the stop.

4.Recheck with the square. Tightening the checknut will move the stop bolt slightly, so some trial-and-error may be necessary to perfect your settings.

90° Stop

Figure 15. Setting the 90° stop.

Ultimate Series Jointers -17-