Grizzly G9859 instruction manual Maintenance, Tables, Lubrication, Belt

SECTION 7: MAINTENANCE

!	Disconnect power to the
	machine	when	perform-
	ing any	maintenance,
	assembly	or	adjust-
	ments. Failure to do this
	may result in serious per-
	sonal injury.

Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.

Wear safety glasses dur- ing the entire mainte- nance process. Failure to comply may result in serious personal injury.

Tables

Tables can be kept rust-free with regular applica- tions of products like Boeshield® T-9. For long term storage you may want to consider products like Kleen Bore's Rust Guardit™.

Lubrication

Since most of the bearings are sealed and per- manently lubricated, simply leave them alone until they need to be replaced. The cutterhead bearings do need grease after every 80 hours of use. Unplug the machine and grease each of the two grease fittings located on each end of the cut- terhead. The front grease fitting is located in a small hole and the other is just under the bottom edge of the fence.

General

Regular periodic maintenance on your Ultimate Series Jointer will ensure its optimum perfor- mance. Make a habit of inspecting your jointer each time you use it. Check for the following con- ditions and repair or replace when necessary.

1.Loose mounting bolts.

2.Worn switch.

3.Worn or damaged cords and plugs.

4.Damaged V-belt.

5.Any other condition that could hamper the safe operation of this machine.

V-Belt

Inspect regularly for wear; replace when neces- sary with a size A-36 belt.

-22- Ultimate Series Jointers