Grizzly G9860 owner manual Cutter edge at top-dead-center

3.Place the straightedge on the center of the outfeed table and over the cutterhead, then use the cutterhead pulley to rotate the cutterhead until the cutter edge is at the top- dead-center, as shown in Figure 23.

Knife-Style Cutterhead

HigV^\]iZY\Z

Note: On the knife-style cutterhead models, rotate the knurled knob on the cutterhead lock pin underneath the back of the fence assem- bly until it pops in toward the cutterhead. As you rotate the cutterhead pulley, the pin will engage one of the four indents on the stop plate and lock the cutterhead in the correct position for this procedure (see Figure 24). To disengage the pin, pull it out and rotate it 1⁄2 turn.

Dji[ZZY	>c[ZZY
Spiral Cutterhead
HigV^\]iZY\Z
Dji[ZZY	>c[ZZY

HideEaViZ>cYZci

AdX`E^c

;ZcXZHjeedgi

@cjgaZY

@cdW

Figure 23. Cutter edge at top-dead-center.

Figure 24. Cutterhead lock pin engaged.

4.When the outfeed table height is correctly set and the cutter is at the top of its rotation, the cutter edge will just touch the straightedge without lifting it.

Note: Use the cutterhead pulley to rock the cutterhead back-and-forth to make sure the cutter is at TDC.

—If your outfeed table height is correctly set, no further adjustments are necessary. Continue with Step 6.

—If the height setting is not correct, continue with Step 5.

-20- Extreme Series Jointer (Mfg. Since 9/11)