-20- Extreme series Jointer (Mfg. since 9/11)
HigV^\]iZY\Z
Dji[ZZY >c[ZZY
Figure 23. Cutter edge at top-dead-center.
HigV^\]iZY\Z
Dji[ZZY >c[ZZY
Knife-style Cutterhead
spiral Cutterhead
Note: On the knife-style cutterhead models,
rotate the knurled knob on the cutterhead lock
pin underneath the back of the fence assem-
bly until it pops in toward the cutterhead. As
you rotate the cutterhead pulley, the pin will
engage one of the four indents on the stop
plate and lock the cutterhead in the correct
position for this procedure (see Figure 24).
To disengage the pin, pull it out and rotate it
1⁄2 turn.
HideEaViZ>cYZci
AdX`E^c
@cjgaZY
@cdW
;ZcXZHjeedgi
Figure 24. Cutterhead lock pin engaged.
3. place the straightedge on the center of
the outfeed table and over the cutterhead,
then use the cutterhead pulley to rotate the
cutterhead until the cutter edge is at the top-
dead-center, as shown in Figure 23.
4. When the outfeed table height is correctly set
and the cutter is at the top of its rotation, the
cutter edge will just touch the straightedge
without lifting it.
Note: Use the cutterhead pulley to rock the
cutterhead back-and-forth to make sure the
cutter is at TDC.
— if your outfeed table height is correctly
set, no further adjustments are necessary.
Continue with Step 6.
— if the height setting is not correct, continue
with Step 5.