DRILL OPERATIONS, CON’T
Operating the drill
1.Set the Direction Switch for the desired rotation of the bit or driver. The direction switch is the sliding switch located just above the trigger. When looking down on the drill, push- ing the switch all the way to the right will give a counterclockwise rotation (normally for loosening fasteners and bits), all the way to the left will be clockwise (normally for tightening fas- teners and drilling holes). When the switch is in the center position it locks to avoid accidentally starting the drill.
2.Set the Torque Setting Ring located just behind the chuck. This ring has 5 settings on it and a pointer indicator
embossed on the drill case. Set on “1” for very light applications such as dri- ving screws into drywall. Use the higher settings for denser woods and materials. Use the drill bit symbol when boring holes. Using the proper torque setting will ensure that the fas- tener is not driven too deeply damag- ing the surface material, or in the worst case, stripped out of the hole due to
3.Pull the trigger to activate the drill.
Torque Setting
Direction Switch
ON/OFF Trigger
Fig 2. Location of controls.
H0603 18V Cordless Drill and Saw |
