Basic Nailer Safety
In addition to the rules stated in the previ- ous section, and those in the warning boxes throughout this manual, please observe the following safety tips for your new nailer:
1.READ THIS ENTIRE MANUAL BEFORE OPERATING THE NAIL- ER.
2.ALWAYS DISCONNECT AIR FROM THE NAILER WHENEVER SERVIC- ING OR INSTALLING NAILS. During maintenance, a nailer connected to air may fire accidentally, causing seri- ous personal injury.
3.DO NOT PLACE HANDS NEAR NAIL POINT OF ENTRY. Nail can deflect and tear through the surface of the workpiece, puncturing your hand or fingers.
4.NEVER CONNECT THE NAILER TO
PRESSURIZED OXYGEN OR OTHER COMBUSTIBLE GASES AS A POWER SOURCE. Only use fil- tered, lubricated, and regulated com- pressed air.
5.NEVER USE GASOLINE OR OTHER FLAMMABLE LIQUIDS TO CLEAN THE NAILER. Vapors in the tool will ignite by a spark and cause the tool to explode.
6.DO NOT CARRY THE NAILER BY ANY OTHER PART THAN THE HANDLE, and do not carry the nailer by the air hose.
7.DO NOT KEEP THE TRIGGER PULLED ON THE SAFETY YOKE MECHANISM WHEN CARRYING OR HOLDING THE TOOL.
8.DO NOT USE A CHECK VALVE OR ANY OTHER FITTING THAT ALLOWS AIR TO REMAIN IN THE TOOL.
Operating this nailer can propel objects into the air, causing immedi- ate eye damage. To protect yourself, always wear American National Standards Institute (ANSI) approved safety glasses or goggles when oper- ating this equipment. In addition, this nailer discharges at
Never point this nailer at yourself or another person! Always pay attention to the direction this nailer is pointed. Use this tool with respect and caution to lessen the possibility of operator or bystander injury. Ignoring this warn- ing may result in serious personal injury.
H2911 18 Gauge Brad Nailer
