Clearing Jammed Nails
The most frequent situation with any type of nailer is a nail jam. A jammed nail must be cleared before using the nailer again. The two places where a nail can get jammed are the magazine and the dis- charge area.
Always disconnect air from nailer whenever clearing a jammed nail!
To clear a jammed nail from the magazine:
1.Disconnect the nailer from the air supply!
2.Open the magazine cover and pull the magazine all the way back.
3.Locate and remove the jammed brad nail with a pair of needle nose pliers. Close the magazine cover so it latch- es.
To clear a jammed nail from the discharge area on the Model H2911:
1.Disconnect the nailer from the air supply! Remove all brad nails from the magazine.
2.Remove the plastic cover from the nose of the nailer.
3.Loosen the 2 cap screws that secure the driver guide cover to the driver guide on the nose assembly. Remove the driver guide cover. See Figure 5 to identify these parts.
4.The jammed nail should now be visi- ble; remove it with needle nose pliers.
5.Install the guide cover and check the safety yoke mechanism for proper operation (following the same instruc- tions as mentioned in the Safety sec- tion).
Guide Cover |
Cap Screws |
Figure 5. Removing guide cover.
Depth Adjustment
1.Rotate the depth adjustment wheel (shown in Figure 6) clockwise to increase the nail depth.
2.Rotate the finger wheel
Figure 6. Depth adjustment wheel.
H2911 18 Gauge Brad Nailer |
