Compressed Air System
The Model H5626/H5627 is designed to be operated at
the maximum operating pressure for your model.
Before you use your new stapler, install the 1⁄4" quick connect fitting that comes with the stapler. Install a female 1⁄4" fitting on the air hose. Regulate the air pressure on your air compressor to barely over the minimum psi for your model.
Many pneumatic tools benefit from an in- line filter/lubricator/regulator unit. Using this unit protects your tool from damaging water
Exceeding the maximum permissible operating pressure may cause the sta- pler to explode, blowing metal frag- ments in all directions. To protect yourself from serious personal injury, DO NOT allow your air compressor to exceed the recommended pressure when connected to this stapler!
H5626/H5627 Upholstery Stapler
Oiling Stapler
Special oil has been included with you new Grizzly stapler to help maintain its useful life. Place one drop of oil in the stapler air inlet (as shown in Figure 1) before every use. Wipe off any excess oil near the sta- pler exhaust to avoid dust
Another option to manual oiling would be to install a lubricator in your air compressor line. If your air compressor line already has a lubricator, then regular lubrication of your stapler will not be necessary. Just make sure there is always oil in the lubricator.
As mentioned before, the best option is to install a filter/lubricator/regulator unit in your air line.
