H6145 28° Clipped Head Framing Nailer
-6-
Compressed Air System
The Model H6145 is design ed to be oper-
ated at 70-120 PSI using clean, dr y, regu-
lated, compre ssed air. DO NOT exc eed
the m aximum operating press ure for
your model.
Before using your new nailer, regulat e the
air pressure on your air compressor to the
minimum PSI for your model.
An in-line filter/lubricator/regula tor unit,
depicted in Figure 2, can be ins talled and
should be located as close to the nailer
as possible.
This filter/lubri cator/regul ator unit will
protect your tool from damaging water
build-up, allow you to ad just and maintain
constant air pressure to your tool, and
save you t he inconvenienc e of having to
manually lubricate your tool every time
you use it.
Quick
Connector
Quick
Coupler
Air Hose Quick
Coupler
Quick
Connector Oiler Filter
Regulator
Air
Compressor
Nailer
Figure 2. Filter/Lubricator/Regulator Unit.
Exceeding the maximum permissible
operating pressure may cause the
nailer to explode, blowing metal frag-
ments in all directions. To protect
yourself from serious personal injury,
DO NOT allow your air compressor to
exceed the recommended pressure
when connected to this nailer!
Check the current Grizzly catalog for avail-
ability of this unit. If you plan on install -
ing a filter /lubricator/regulator unit in your
compressed air system, always fol low the
connection instructions th at come with
the unit.