Installing the Router Base
The router base transforms the mini grind- er into a mini router. It can be used with Grizzly's mini router bits to round over corners or apply profiles to the edges of your workpiece. It can also be used with the included tool bits to mill grooves, or drill holes to consistent depths.
To install the flashlight base:
1.Unplug the tool from power!
2.Remove the collet shield.
3.Install the desired tool bit.
4.Screw the router base onto the mini grinder in place of the collet shield.
5.Adjust the height of the router base by loosening the screw shown in Figure 5, and sliding the router base to the desired height. Tighten the screw in the side of the router base.
Figure 5. Router base.
Using the Tool Holder
Use the tool holder to hold the mini grinder when using the flex shaft.
To use the tool holder:
1.Slide the threaded base of the tool holder into the hole in the clamp base.
2.Thread the nut onto the base of the tool holder, then rotate the tool holder until it is firmly attached to the clamp base.
3.Clamp the base to a table or other sturdy object. Make sure the base can- not rotate loose.
4.Extend the tool holder by rotating the shaft to loosen the joints, and then extending each section.
5.Rotate the shaft in the opposite direc- tion to tighten it at the right height.
6.Fold out the hanger on the mini grinder and hang it from the hook.
Model H6155 Rotary Mini Grinder |
