MODEL H8175 |
PROFESSIONAL |
PNEUMATIC GLUE GUN |
INSTRUCTION SHEET |
Case |
EYE/SKIN BURN HAZARD!
Wear safety glasses and protective clothing when using this tool!
| INJURY HAZARD! |
| Air |
| |
| Always disconnect tool from |
|
| ||
| Regulator |
| |||
| air to prevent | unexpected | Gun | ||
|
|
| |||
| operation during service! |
|
|
| |
| DO NOT EXCEED 100 PSI! |
|
|
| |
| Personal injury could | Screwdriver |
| ||
| occur. |
| Extra Nozzles | ||
|
|
|
|
| |
| ELECTRICITY | HAZARD! |
| Figure 1. Model H8175. | |
| Electrocution or fire could |
| |||
| result if this tool is not |
|
|
| |
| properly grounded. Do not | 4. | Insert a 1⁄2" diameter glue stick into the back | ||
| remove the ground pin. |
| of the gun. |
| |
Specifications |
| 5. | Once the gun has fully heated, slowly squeeze | ||
|
| the trigger until the melted material begins to | |||
Air Regulator Inlet Size | 1⁄4" NPT |
| |||
| flow from the nozzle. |
| |||
Operating Temperature |
|
| |||
|
|
| |||
Maximum Temperature | 446°F |
| Note: When hot, rest the gun with the tip fac- | ||
Operating Air Pressure | 90 PSI |
| |||
| ing down, as shown in Figure 1, to prevent | ||||
Glue Stick Diameter | 1⁄2" |
| |||
| melted glue from escaping the chamber and | ||||
Cord Length | 2 ft. |
| |||
| increasing the risk of fire or personal injury. | ||||
Weight | 3 lbs |
| |||
|
|
| |||
Operation |
| 6. After the gluing operation is complete, allow | |||
|
| the glue gun to fully cool before storing it. | |||
1. | Connect the glue gun to the air regulator and |
| |||
| Glue sticks may remain in the glue gun when | ||||
| connect the air regulator to the air supply. |
| |||
|
| it is not in use and be | |||
|
|
|
| ||
2. Plug the glue gun into a grounded outlet and |
| glue gun is used again. |
| ||
|
|
| |||
| turn it ON with the power switch located at the |
| Note: Never pull the glue stick out through | ||
| base of the glue gun. |
|
| ||
|
|
| the back of the gun or it may damage the | ||
|
|
|
| ||
3. | Allow the gun to heat up for approximately |
| feed mechanism. Cut off the extra portion of | ||
| the glue and feed the remainder through the | ||||
| minutes. |
|
| ||
|
|
| glue gun. |
| |
|
|
|
|
| |
| Copyright © May, 2008 By Grizzly Industrial, Inc. |
| |||
| Warning: No portion of this manual may be reproduced in any shape | ||||
| Or form without the written approval of Grizzly Industrial, inc. |
| |||
|
| #JM10780 printed in TAIWAN |
| ||
