![](/images/new-backgrounds/1136789/13678939x1.webp)
2.Allow only enough slack in the string for
Note: If too much slack is allowed, then the string could wind off the tuning post after many successive rotations. If not enough slack is allowed, then the string may not hold the winding tension.
3.Use wire cutters (optional) to cut off excess string.
4.Bend the string at a right angle and insert it into the tuning post slot.
5.Rotate the tuners until the string just begins to hold the winding tension (Figure 29).
Note: DO NOT tighten the strings beyond the initial tensioning at this time. Final tensioning should be completed during the string tuning process.
Tuning Post
String End | Slot |
|