Grizzly H8230, H8231 owner manual Operations, Loading

OPERATIONS

Loading

When replacing nails in your Model H8230/H8231, follow these guidelines:

Nail Type: Flat Wire Welded Coil 15° Roofing Nail

Length: H8230 3⁄4"–13⁄4"

H8231 13⁄4"–23⁄4"

Capacity: H8230 120 Nails

H8231 225–300 Nails

To load your nailer:

1.DISCONNECT NAILER FROM THE AIR SUPPLY!

2.Squeeze the latch shown in Figure 3, then open the feeder cover and maga- zine, as shown in Figure 4.

Latch

Figure 3. Feeder cover latch.

Figure 4. Feeder cover & magazine open.

H8230/H8231 15° Roofing Nailer

3.Pull up and rotate the adjusting plate, shown in Figure 5, to match the maga- zine mark with the nail length to be installed. (Rotating the adjusting plate locks or unlocks its position.)

Figure 5. Adjusting plate.

4.Place the nails over the adjusting plate post, and put the first nail into the feeder pawls as shown in Figure 6.

Feeder Pawls

Figure 6. Loading nails in the magazine.

5.Close the magazine cover, then close the drive hole and feeder cover and latch it closed.

-7-