Grizzly T10044 instruction sheet Assembly, Screw, Frame

Assembly

1.Attach the impeller to the gear box and axle assembly with the Phillips head screw, as shown in Figure 3.

Phillips Head	Hole
Screw

Figure 3. Impeller attached to gearbox assem-

bly.

2.Slide the left and right wheel frames onto the gear box axle. Attach the connecting rod to the wheel frames using the M6-1 X 45 hex bolts, as shown in Figure 4. Make sure that the hole in the gear box axle is on the right hand side, so the impeller will spin in the proper direction (clockwise) after assembly.

Right Wheel		Left Wheel
Frame		Frame
	Connecting Rod	Hole
Hex Bolt		Hex Bolt

Figure 4. Frame assembly.

3.Slide the impeller rod into the base of the hopper making sure that the small protrusion in the gear box is facing towards the back. Attach the wheel assembly frames and the support leg to the hopper assembly using the M6-1 X 65 hex bolts, 6mm flat washers, and four of the M6-1 lock nuts, as shown in Figure 5.

Protrusion

Hole

Support Leg

Hex Bolts

Figure 5. Lower hopper assembly.

4.Insert the inner axle bushings onto the gear box axle so that they are snug inside the outer axle bushing of the wheel assembly frames. Slide the wheels onto the gear box axle. Secure the left wheel to the axle using the M5-.8 X 45 hex bolt and M5-.8 lock nut. Using a wooden or rubber hammer, install the axle end covers.

Hex Bolt

Outer Bushing

Inner Bushing

End Cover

Figure 6. Wheel assembly.

-2- T10044 80 lb. Seed/Fertilizer Spreader