Assembly
Adjusting the Wheel Guard
The wheel guards can be adjusted for maximum safety during grinding operations.
To adjust the guard:
1.Remove the wheel and both flanges.
2.Loosen the three Phillips head screws in the guard plate.
3.Rotate wheel guard to the desired position and retighten the screws loos- ened in Step 2.
Note: The mounting hardware for Model T10493 and Models T10494 and T10495 are different. For Model T10493, ensure that the guard plate clip is seated in one of the five posi- tion holes on the wheel guard, as shown in Figure 4.
Guard Plate
Clip
Phillips Head
Screw
Position
Holes
Figure 4. Adjusting the T10493 wheel guard.
4.Re-install the wheel and flanges (refer to Installing/Changing Grinding Wheels on Page 16).
Always consider the position of the wheel guard when installing the handle. NEVER operate the grinder with the handle installed toward the open face of the guard. This could lead to injury.
Installing the Handle
These Angle Grinders include a handle and mounting holes for different handle configurations, as shown in Figures
Figure 5. Three handle configurations for T10494/T10495.
Figure 6. Two handle configurations for the T10493.
T10493, T10494 & T10495 (Mfg Since 10/11) |
