Recording Fingerprint, Recording PIN Number

Most of the safe operations are time sensi- tive. In general, you will have approximately five seconds between finishing one action in the procedure and starting the next. Otherwise, you will have to start with Step 1 to begin the procedure again.

Recording Fingerprint

1.With the safe door open, then press and release the reset button.

2.Place your fingertip on the fingerprint scanner with medium pressure.

—If properly recorded, the green light will flash once, then, after a pause, flash again.

—If the red and green lights flash together, the fingerprint was not recorded. Try again.

Recording PIN Number

1.Press and hold the number “1” key on the PIN pad until the green light flashes once, then, after a pause, flashes again.

Note: The default factory-set PIN number is “1234”.

2.Enter the current PIN number and press the activating button.

—If the PIN number was accepted, the green light will flash once.

3.Enter the new PIN number and press the activation button.

Note: PIN numbers must be 4–8 numbers in length.

4.Repeat Step 3.

—If properly recorded, the green light will flash once, then, after a pause, flash again.

—If the red and green lights flash together, the PIN number was not recorded. Try again.

Model T10722/T10723 (Mfg. Since 01/13)

Locking Safe

To lock the safe, make sure the dead bolts are withdrawn into the door, then close the door and rotate the door handle counterclockwise 1⁄4 turn.

Unlocking with Fingerprint

1.Press and release the activation button.

2.When the fingerprint scanner lights up, place your fingerprint on the scanner with medium pressure.

—If your fingerprint was verified, the green light will flash once, then, after a pause, will remain lit for approximately five seconds. During this time, use the door handle to unlock and open the door.

—If the red and green lights flash together, the fingerprint was not verified. Try again.

Unlocking with PIN Number

1.Use the PIN pad to enter the PIN number and press the activation button.

—If the PIN number was verified, the green light will flash once, then, after a pause, will remain lit for approximately five seconds. During this time, use the door handle to unlock and open the door.

—If the red and green lights flash together, the fingerprint was not verified. Try again.

Re-setting to Factory Defaults

1.Open the door, then press and hold the reset button until the following sequence is com- plete:

•One beep with a flash of the green light.

•15 flashes of the green light.