Grizzly T10723, T10722 specifications Mounting Safe, Batteries, Troubleshooting Cleaning

Mounting Safe

The safe has holes through the back and bottom for mounting to a wall or floor.

When mounting to a wall, we recommend secur- ing 1" wood stock to the wall studs, then securing the safe to the wood. Make sure the mounting will hold the weight of the safe and contents, as well as the forces of opening and locking the door.

Batteries

The electronics of the safe are powered by four

AAbatteries. If the fingerprint scanner or PIN pad does not respond or if the red light on the security pad stays ON when attempting a procedure, the batteries need to be replaced.

Use the key to open the safe and replace the batteries with four high-quality AA alkaline batter- ies. Refer to Installing Batteries on Page 2 for detailed instructions.

Note: When the batteries are removed, the record- ed fingerprint scans and PIN number stay in non- volatile memory and will remain functional when the batteries are replaced.

Troubleshooting

Cleaning

Use a soft cloth moistened with warm water to clean the painted surfaces of the safe. Do not use solvents, abrasives, or spray cleaners that can damage the finish or electronic components.

Always keep liquids away from the security pad and the battery compartment to prevent damaging the electronic components.

Regularly clean the fingerprint scanner lens with a soft cloth moistened with warm water. Do not use paper products that can scratch the lens. Do not use chemicals or spray cleaners that can damage the lens or electronic components.

Review the troubleshooting and procedures in this section if a problem develops with your safe. If you need additional help with a procedure, call our Technical Support at (570) 546-9963.

Note: Grizzly cannot replace lost or stolen keys. Please contact your local locksmith if this happens.

Symptom	Possible Cause		Possible Solution
Security pad	1.	Batteries are low or dead.	1.	Replace batteries.
does not properly	2.	Electronic components are at fault.	2.	Replace safe or use keys to operate.
respond to input;
red light stays on.
Fingerprint scanner	1.	Scanner lens is dirty.	1.	Clean scanner lens.
will not record	2.	Fingerprint not readable.	2.	Follow the Fingerprint Scanning Tips on Page 2.
fingerprint.	3.	Security pad memory has reached maximum	3.	Erase security pad memory by re-setting to factory
		limit of 32 fingerprint scans.		defaults.

-4- Model T10722/T10723 (Mfg. Since 01/13)