MODEL H8165/66/67/68

NOISE REDUCTION KIT

FOR CYCLONE DUST

COLLECTORS

Introduction

These noise reduction kits significantly reduce

 

 

 

Wire Hose

the noise level of cyclone dust collectors without

 

Clamp

causing efficiency loss.

 

 

 

 

 

 

 

 

Installation Instructions

 

Muffler

 

 

 

 

 

 

 

Wire Hose

The mufflers are best installed in the outlet hose,

 

Clamp

as close to the filter as possible. The installation

 

 

 

 

 

 

 

consists of removing a section of the outlet hose

 

 

 

and installing the muffler in its place. Wire hose

 

 

 

clamps are provided to secure the muffler to the

 

 

 

outlet hose (see Figure 1).

 

 

 

To install the muffler:

Figure 1. Noise reducing kit installed.

1.Measure the size of the muffler body (see

Figure 2).

 

 

Foam

2. Using a felt-tip marker, mark a section of

 

 

Tape

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

the outlet hose equal in length to the muffler

 

 

 

 

 

body. IMPORTANT: Leave at least 4" of out-

 

 

 

 

 

let hose between the filter and the muffler.

 

 

Muffler

 

 

 

Body

3.Remove the portion of the outlet hose marked in Step 2.

4. Fit the wire hose clamps over the ends of the

 

 

 

 

 

 

 

 

Foam

 

 

 

 

 

outlet hose and slide them back at least 2"

 

 

 

Tape

 

 

 

 

from the opening.

 

 

 

 

 

 

Figure 2. Size of muffler body.

 

5.Apply the 3 x 15mm foam tape to the top and

bottom rims of the muffler (see Figure 2).

If you need help installing the noise reducing kit,

 

call our Tech Support at: (570) 546-9663.

6.Fit the ends of the outlet hose completely over the ends of the muffler.

7.Slide the wire hose clamps down to the end of the hose near the body, then tighten them to secure the muffler in place.

Copyright © November, 2006 By Grizzly Industrial, Inc. Revised November, 2009.

Warning: No portion of this manual may be reproduced in any shape

Or form without the written approval of Grizzly Industrial, inc.

#TR8803 printed in TAIWAN

Page 1
Image 1
Grizzly TR8803 installation instructions Noise Reduction KIT, For Cyclone Dust, Collectors, Introduction