Groupe SEB USA - T-FAL 8819 Wiring Instructions, Safety Warnings, About your factory fitted plug

Models: 8819 8820 8826

1 2
Download 2 pages 43.89 Kb
Page 2
Image 2
SAFETY WARNINGS

SAFETY WARNINGS

Be sure the power supply corresponds to that shown on the rating plate of the appliance. Be sure your socket is fitted with an earth pin.

Keep out of the reach of children.

Always disconnect from the mains supply when not in use and before cleaning.

Do not use the appliance if either it or the cord is damaged, it has been dropped and is visi- bly damaged or functions abnormally.

If an extension lead is used, it must be earthed in good condition.

Do not immerse the appliance, plug or cord in water.

The safety of this appliance complies whith the technical regulations and standards in force.

The appliance cannot be opened without special tools, therefore for any cleaning and repairs, you must consult an authorised service centre.

This appliance has been designed for domestic use only.

The manufacturer accepts no liability if the appliance is used for commercial purposes or in a manner which does not comply with the operating instructions.

WIRING INSTRUCTIONS

Warning :

this appliance must be earthed.

Important :

the wires in this lead are coloured in accordance with the following codes:

Green and Yellow : earth

Brown : live

Blue : neutral

(for uk only)

Green and

L Brown or red

yellow

or green

 

E

Fit correct fuse

N Blue or

Use cable gripper

black

 

Connect the green/yellow wire to the terminal in the plug marked “E” or by the earth symbol or coloured green or coloured green and yellow.

Connect the brown wire to the terminal in the plug marked “L” or coloured red.

Connect the blue wire to the terminal in the plug marked “N” or coloured black.

A 13 amp fuse should be fitted when the appliance is connected to a BS1363 A plug.

Seek professional advice if unsure of the correct procedure for the above.

Important : if the electrical cord of this appliance is damaged or shows signs of wear, it must only be replaced by an authorised Tefal Service Centre (see section After Sales Service).

About your factory fitted plug

(supplied with certain models only)

The cord is already fitted with a plug incorporating an appropriate fuse. If the plug does not fit your socket outlet, see paragraph below. Should you need to replace the fuse in the plug supplied an appropriately rated approved BS 1362 fuse must be used (refer to wiring instruc- tions specification for fuse rating). If the plug supplied does not fit your socket outlet, it should be removed from the mains lead and disposed of safety. The flexible cord insulation should be stripped back as appropriate and a suitable alternative plug fitted.

If the plug has external access to the fuse (non-rewirable type plug) please note that the fuse cover is an important part of the plug. Please ensure that it is always refitted correctly. If you lose this cover please do not use the plug. You may contact Tefal UKLimited for a replace- ment.

After sales service information

(for UK only):

If you have any problems or queries, please telephone our Customer Relations

HELPLINE:

0845 602 1454 - UK ( calls charged at local rate) (01) 47 51947 - Ireland

Page 2
Image 2
Groupe SEB USA - T-FAL 8819, 8826, 8820 manual Wiring Instructions, Safety Warnings, About your factory fitted plug