Maintenance and cleaning

Spray Function

•Whether steam or dry ironing, you are able to use the Spray button (fig.6) to dampen laundry to remove stubborn creases.

•Set the steam control to and unplug the iron.

•Wait until the soleplate cools down and empty the tank. A little water may remain in the tank.

•Wind the cord around the heel of the iron.

•Store the cold iron on its heel (fig.7).

•Unplug your iron and empty the water tank.

•Remove the anti-calc valve (fig.8).

•Soak the valve in a cup of white vinegar or plain lemon juice for 4 hours. (fig.9).

•Rinse the valve under running water and replace the anti-calc valve.

The iron will not function without the anti-calc valve. Never touch the end of the valve !

To slow down scaling and prolong the useful life of your iron, carry out the self-cleaning operation once a month.

•Unplug your iron, set the steam control to and fill the water reservoir to MAX.

•Place your iron on its heel, set the thermostat button to MAX, plug in your iron and wait for the indicator light to go out.

•Unplug the iron and place it horizontally over a sink.

•Remove the anticalc valve (fig.8).

•Gently shake the iron over the sink until some of the water (along with impurities) runs out through the soleplate.

•At the end of the operation, put the anticalc valve back in place and then plug in your iron for 2 minutes on its heel to dry the soleplate.

• Unplug the iron, and when the soleplate is just warm, wipe it with a soft Never use abrasive or

cloth.	aggressive products.