Grundig CDS 6580 A SPCD Connecting the antenna, Connecting an external device, Connecting the headphones, Connecting the power cord

12
Connecting the antenna
1Plug the rooftop antenna cable into the »FM ANTENNA«
antenna socket on the hi-fi.
Note:
If no rooftop antenna is available, use the auxiliary antenna
supplied. This antenna provides reasonably good reception of
local FM (VHF) stations. Do not shorten the auxiliary antenna.
2Insert the wire frame antenna cable into the »MW ANTEN-
NA« terminals on the hi-fi system. Adjust the position of the
wire frame antenna until you get the best reception.
Connecting an external device
1Connect the audio input sockets of the external device to the
»AUX« socket on the right side of the hi-fi system with a stereo
jack plug (ø 3,5 mm).
Note:
Switch the hi-fi system off before you connect external devices.
Connecting the headphones
1Insert the headphone plug (ø 3,5 mm) into the »y« socket on
the right side of the hi-fi.
– The loudspeakers of the hi-fi system are switched off.
Note:
Excessive sound pressure from the earphones or headphones
can cause hearing loss.
Connecting the power cord
Note:
Check that the mains voltage on the type plate (on the bottom of
the hi-fi system) corresponds to your local mains supply.
1Plug the mains cable supplied into the »AC ~« socket on the
hi-fi system.
2Plug the power cord into the wall socket.
Caution:
The hi-fi system is connected to the mains with the power cord.
Pull out the power cord when you want to completely disconnect
the hi-fi system from the mains.
Unplug the mains plug to disconnect the hi-fi system from the
mains. Make sure the power plug is easily accessible during
operation and not hindered by other objects.
CONNECTION AND PREPARATION_