Grundig CP-731i Power Connection, Example of system setup, Plug & Play, INSTALLATION continued

INSTALLATION (continued)

Power Connection

Use the correct one of the enclosed power cords depending on the power outlet to be used. Connect the AC inlet of the projector to the power outlet firmly by the power cord.

WARNING		Power outlet
• Handle the power cord according to instructions of the
accompanying manual "SAFETY INSTRUCTIONS"
and this manual.
• Connect the power cord firmly. Avoid using a loose,
unsound outlet or contact failure.	Power Cord	AC Inlet

Example of system setup

Video tape recorder
with S jack
Video tape recorder
			Computer
			(notebook type)
1	RGB IN	2	RGB Cable
AUDIO IN VIDEO IN S-VIDEO IN

AUDIO￿1 2 AUDIO OUT USB

IN

RGB OUT CONTROL

RS-232C

Cable

Computer (desktop type)

Speaker (with built-in amp) Display monitor

NOTE:

When connecting with notebook computer, set to valid the RGB external image output (setting CRT display or simultaneous display of LCD and CRT).Please read instruction manual of the notebook for more information.

Plug & Play

This projector is VESA DDC 1/2B compatible. Plug & play is possible by connecting to a computer that is VESA DDC (Display Data Channel) compatible.

(Plug & play is a system configured with peripheral equipment including a computer and display, and an operating system.

NOTE:

•Use the RGB cable included with this projector when using plug & play. With other cables, pins (12) (14) (15) are sometimes not connected.

•Plug & play is available only when the RGB cable is connected to the RGB IN 1 terminal.

ENGLISH-8