OPERATION___________________________
7Keep the strands of hair smooth to avoid ridges.
6 Repeat this procedure with steps
2 to 5.
7 After using the appliance, switch off the appliance using switch B and disconnect the power cord from the mains.
–Power on indicator light C disappears.
Note
7Allow the hair styler to cool down fully before storing.
Styling waves or curls
1 Plug appliance into a suitable mains supply.
2 Switch the hair styler on using the On/Off switch B .
–The power on indicator light C illuminates.
Note
7Make sure your hair is completely dry.
3 Comb or brush out a section of hair approximately 3 cm in width, starting at the neck.
4 Place the section of hair between the plates A , as near to the hair line as you can, and then close them.
5 Depending on the hair style, rotate the appliance so that the hair wraps around it at the height of the plates A .
6 Slowly pull the appliance towards the ends of the hair.
–A curl is formed once the ap- pliance has been pulled down and over the ends of the hair.
7 Repeat this procedure section by section.
8 After using the appliance, switch off the appliance using switch B and disconnect the power cord from the mains.
–Power on indicator light C disappears.
Note
7Allow the hair styler to cool down fully before storing.
Hints and tips
7Hair should be completely dry to achieve the best results.
7Keep the strands of hair smooth whilst you work, to avoid ridges part way down the strand.
7As with all hair stylers that reach high salon temperatures, do not use the appliance frequently to avoid damage to hair.
16 ENGLISH
