GTO 352 Setting the Open Position Limit, Press the SET Limit on the Master ARM for 5 Seconds

Step 3

With the gate in the fully closed position and the opener retracted, swing the opener to the gate. Mark reference points for bolt holes on gate cross member through middle of gate bracket slots. The opener must be level. (Some vertical adjustment is possible by sliding the post bracket assembly up and down.)

Drill 3/8" holes into the gate cross member as marked. Fasten gate bracket to cross member using (2) 3/8" x 3" bolts, washers, lock washers, and nuts. Attach the opener to the post bracket assembly and gate bracket using clevis pins, bushings, and hairpins clips.

Fence Post	Gate Post and Gate Cross Member
	(In Closed Position)

Operator

LEVEL

POST PIVOT BRACKET level with the horizontal surface of the GATE BRACKET

Step 4

Make sure the control box power switch is OFF. Use a small screwdriver to move the Number 1 DIP switch from the factory setting (OFF / Pull-To-Open) to ON for Push-To-Open.Turn power switch ON. The control board is now configured to push the gate open.

LEVELMIN	MAX
STALL FORCE

OFF 120

CLOSE TIME

			SET	LEARN
			LIMIT	REMOTE
151	ON PULL-PUSH
2	MODE1	1	ON PULL-PUSH
3	MODE2	23	MODE2
	LOCK/BEACON		MODE1
4		4	LOCK/BEACON

CHARGING	RF
POWER

LINK

		18VAC	EXIT	SAFETY	EDGE	CYCLE	COMMON	GRN	RCVRBLK	RED
AUX OUT
		PANEL
	SOLAR

Setting the Open Position Limit

Step 1

Confirm that the power switch is in the ON position, and the gate is in the CLOSED POSITION.

Step 2

Activate your opener by pressing the entry transmitter. Your gates should now be moving from the fully CLOSED POSITION toward the opening position. Press the transmitter again to stop the gate at the desired OPEN position. Note: whichever gate reached its desired open position first that will be the first one to be programmed.

•If the second arm is stopped at the desired open position, press the 'SET LIMIT' on the SECOND ARM FOR 5 SECONDS.

•If the master arm is stopped at the desired open postion,

press the 'SET LIMIT' on the MASTER ARM FOR 5 SECONDS.

M i g h t y M u l e 3 5 2 37