Guardian Technologies GGS50 warranty Assembly, Charging, Directions for use, Stick Vac, Hand VAC

Assembly

1.Press handle assembly button while inserting the handle into the handle opening on the main body making sure not to pinch internal cord. Handle assembly button will snap into place when handle is fully connected. (Fig. 1)

2.Attach the power nozzle into the air intake of the main body making sure contacts between the nozzle and body are aligned and inserted completely. (Fig. 2)

Fig. 1 Fig. 2 Fig. 3

Charging

NOTE: Use only the charger supplied by the manufacturer to recharge.

IMPORTANT: Before first use, charge your vacuum for at least 24 hours.

Both power switches must be in the OFF position when unit is charging on base. If charging light is not illuminated, press ON/OFF button to assure unit is turned off. Remember, unit will not charge if charging light is not illuminated.

CAUTION: Do not allow the battery to run down completely before charging. Running down battery will cause battery life to shorten severely.

1.Connect charger into the charging port located on the side of the vacuum (in the hand vac). (Fig. 3) Charge unit with hand vac stored on-board.

2.Connect wall charger to the outlet.

3.A red charging light will illuminate when unit is charging. Unit will be charged in

16-24 hours. Recharge unit as soon as the motor power decreases noticeably. The unit can be on a constant charge so it is always ready for use.

4.The light stays on and remains the same color even when the unit is fully charged.

Directions for use

STICK VAC

NOTE: Be sure hand vac is properly stored on-board before using stick vac.

1. Slide the Selector switch to either FLOOR
(suction only/brushroll off) or CARPET
(suction with brushroll on). (Fig. 4)	Fig. 4

2.Use complete stick vac to remove dust and debris from barefloors and carpets.

3.Tools can be inserted at bottom of stick vac by removing nozzle base and inserting tool into opening. Ideal for hard-to-reach, above floor cleaning.

Fig. 5 Fig. 6 Fig. 7

Hand VAC

1.Press two side HAND VAC RELEASE buttons and pull the hand vac from the main unit. (Fig. 5)

2.Turn power switch ON.

3. Use for above floor cleaning such as counters, upholstery etc.

4.Insert crevice tool/dust brush into the opening of nozzle to extend reach. (Fig. 6)

5.To replace the handheld unit, insert the dirt cup into the main body first then press the upper portion of the hand vac into the main body until it’s secure. (Fig. 7)

6. Empty and clean dirt cup and filter after each use or when cup is full.

E-4 E-5