H1500REV0509:Ultrasonic Humidifier Manual 2L 5/18/09 1:42 PM Page 3
| WARNINGS |
! | This product should be used only in accordance with the specifications outlined in this |
manual. Usage other than what has been specified here may result in serious injury. |
WARNING: THE CORDS, WIRES, AND/OR CABLES SUPPLIED WITH THIS PRODUCT CONTAINS CHEMICALS, INCLUDING LEAD OR LEAD COMPOUNDS, KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM, WASH HANDS AFTER USING.
DIRECTIONS FOR USE (cont.)
·Disassembly, repair or remodeling by an unauthorized person may result in serious harm.
·Do not use if plug is damaged or loose.
·Keep this product out of the reach of children and pets.
·Be careful not to put water in the humidity spout.
·Before filling or cleaning the unit, make sure it is unplugged.
·Once the humidifier has been turned on, do not move it.
·Do not remove the water tank from the unit while it is on.
·Do not handle the plug with wet hands.
·Do not excessively bend, twist or pull the power cord.
·Avoid placing this product where the humidity spout is pointed directly at an object.
·Do not inhale water mist directly from the humidity spout
·Do not place this product on a sloped, unstable, absorbent or soft surface.
·When not in use, unplug the unit.
·Do not fill the water tank with hot or boiling water.
·Do not use this product in direct sunlight, or near a gas stove or heater.
·If the water tank becomes cracked or damaged, do not use.
·Do not keep this product running for an extended period of time without proper maintenance.
·Do not clean the unit or water tank with detergents or chemicals of any kind.
·Do not use this product near any other electronic device.
·Do not cover the humidity spout opening at any time during use.
·Do not use this product near a sink.
·Do not drink the water from the water tank.
DIRECTIONS FOR USE
Make sure the unit is unplugged.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1. Separate the tank from the |
|
| 2. Turn water tank over. Open tank | ||||
body of the unit. |
|
| lid, twisting the cap to the left. | ||||
3.Pour cool, clean water directly into the tank. Do not pour anything but water into the water tank.
5.Attach the water tank to the body of the unit and plug in.
Spray
7.Turn the spray volume knob to
the right to increase mist /humidity level. Turn left and the humidity/mist level decreases.
4.Close the tank lid, twisting the cap to the right.
6.To select the temperature of humidity turn the mode dial to cool or warm. The Power LED will light up.
8.As soon as the Refill LED lights up, turn the unit off and refill the water tank.
