6.Power Button
Before turning on make sure there is water in the unit. Press the POWER button.
9.Night Light Feature
Press the Night Lamp button at the top of the unit to illuminate the night light feature.
7.Cool or Warm Humidification Button
Press to select cool or warm mist. Water temperature is maintained at room temperature for cool setting and 80 degrees for warm.
10.Water Refill Button
When the Water Refill | button lights |
up it is time to refill the | water tank. |
8.Spray Control Button
When you press the Spray Control button there are three options: Press once for LOW
Press twice for MEDIUM Press three times for HIGH
*Lights get higher as spray increases.
11.Humidity Spout Direction
Broaden mist in two different directions throughout the room.
•Always unplug the unit before servicing it in any way.
•The water temperature of the water remaining in the unit after use may be high.
•Do not submerse the unit in the water, or allow water to enter the inside of the unit.
INSIDE THE BODY OF THE UNIT
Pour excess water out of the unit, but do not allow it to enter the blast port. Wash out the unit with fresh water using the cleaning brush and a soft cloth as needed.
OUTER SURFACE OF THE UNIT
Wipe the surface of the unit with a soft, damp cloth if needed.
WATER TANK
If water spots remain in the water tank, wipe the inside down with a soft cloth. Do NOT use soap or detergents.
ULTRASONIC DISK
Remove the tank (Fig. 1) and use ONLY the enclosed cleaning brush to regularly remove build up and deposits from the disk area (Fig. 2).
**Diluted white vinegar will help to prevent this build up.
*Clean the disk with the brush only. No other cleaning tool should be used. BRUSH ONLY. (Fig. 2)
Ultrasonic Disk
(Fig. 1) | (Fig. 2) |
•Clean and fully dry the inside and outside of the unit before storing it.
•DO NOT leave water in the unit.
•Store in a cool, dry place.
