Guardian Telecom Inc.
Installation and Operation
Model
Installing the
•
•The
•Follow all appropriate electrical codes and use only approved electrical fittings for the installation.
•Choose a wall location that is free of obstructions and permits space for wiring.
•Ensure mounting can support 6.5 lbs (2.95 kg) plus any additional, foreseeable load.
•Ensure that none of the electrical connection circuits are live.
Mounting
•Use the template or the unit itself to locate and drill holes for mounting screws.
•Secure the unit to the wall.
Hard Wiring the WRT-A to the Telephone System
•Remove the wiring access cover plate.
•Install a suitable conduit hub or cable gland in the cable entrance hole.
•Bring cable into the enclosure through the cable entrance and attach individual wires from the exchange – Tip/Ring/Ground – to the surge arrestor (Tip & Ring are not polarity sensitive).
WARNING
Protective earthing terminal of the phone shall be properly hardwired
to a protective earth system.
•Replace the wiring access cover plate.
Final Check
•Check the set visually for loose screws and trapped wires. Check that the handset hangs freely in the cradle and that the handset cord is not trapped by the door.
•Check that the faceplate is snug to its gasket, paying particular attention to the area around the cradle. Check that the door closes flush to the housing.
•Test the unit by calling to and from another unit on the exchange.
See: Figure 3 - Setting
Dialing Mode &
Installation
See: Figure 2 - Overall Dimensions
Operation
•Once your Model
WARNING
Due to magnetic fields, it is possible that dangerous objects may get trapped within the earcap region of this device.
Page 5
