Guardian Telecom Inc.
Installation and Operation
Model
Setting Dialing Mode
The
•Loosen the five captive screws in the faceplate and swing the faceplate to the left. If the set is on a vertical surface the faceplate will stay open like a book in this position. Take care not to disturb the internal wiring.
•Change the position of the Tone/Pulse jumper on the circuit board to Pulse, as indicated on the label.
•The set will now be in pulse dialing mode, it can be returned to tone mode by changing the position of the jumper back to the Tone position.
•Carefully replace the front plate and install all five screws. Do not over tighten the cover screws, there is a flexible gasket between the cover and the body. Excessive tightening of the screws deforms the gasket and reduces the weather resistance of the set.
See: Figure 3 - Setting
Dialing Mode &
Installation
F | Guardian Telecom Inc. | S/N:____________ | |||
| Calgary, Canada |
|
| ||
| PHONE | RIN- | HK | HANDSET | TONE/ |
| LINE | GER | SW |
| PULSE |
TONE/PULSE JUMPER
GROUND CONNECTION
TIP & RING CONNECTION
Figure 3 - Setting Dialing Mode & Installation
Page 6
