H2O Audio iDV1-5A1, iDV1-75 VI. Insert iPod, VII. Operation, Power On/Off, iPod Authentication

VI. Insert iPod

1.Ensure the correct inserts and height adjusters are installed for your iPod

(PLEASE NOTE: If the correct insert and height adjusters are not used

you may damage or destroy your iPod and the iDive300)

2.Place iPod in the inserts with the iPod dock connector facing toward the cam knob.

3.Insert the connector cable into the dock connector of the iPod with the H2O Audio logo facing up.

4.Depending on your iPod model, press and hold the “Play / Pause” button or press the Power button to turn the iPod on.

5.IMPORTANT: For touch-screen iPod models, to prevent the display screen from locking, access the General Settings to turn the Auto-Lock feature off.

-Settings - General - Auto-Lock - “Never”

VII. Operation

Menu	Previous/Fast-forward
Up	Volume	Play/Pause
Down
	Controls		Mode
Select		Next/Fast-forward	Power

Power On/Off

Press and hold the power button for 2 seconds to turn the iDive300 on/off.

After turning the iDive300 on, all 3 LEDs on the back of the case should illuminate within a few seconds. If connected successfully only the Green LED should remain lit.

iPod Authentication

Green LED indicates successful connection of the iPod.

Red LED indicates a failed connection of the iPod.

When the Red LED is illuminated, controls will be limited to adjusting the volume of the built-in amplifier.

Blue LED indicates that the authentication timed out.

When the Blue LED is illuminated there is some limited function of the iPod controls.

In case of a Blue LED

Restart the iDive300 by turning the power off then on. If this does not solve the problem:

1.Turn off the iDive300.

2.Disconnect the connector cable from the iPod.

3.Ensure the iPod is on.

4.Reconnect the connector cable to the iPod.

5.Turn on the iDive300.

11 12