H2O Audio iDV1-75, iDV1-5A1 specs

Q:Why is the Red LED ﬂashing?

A:The iDive300 is designed to measure battery-life of the 3-AA batteries that are used to power

the “Made for iPod” connection electronics and the power ampliﬁer. The Red LED will start to ﬂash when the batteries have approximately 25% charge remaining. Note, the battery indicator of the iPod does not reﬂect the power remaining in the 3-AA batteries.

Notes:

-“Made for iPod” means that an electronic accessory has been designed to connect speciﬁcally to iPod and has been certiﬁed by the developer to meet Apple performance standards.

-Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.

Page 13

Image 13

Contents

Page w w w . H 2 O A u d i o . c o m D e p t h R a t i n g 3 0 0 f t / 9 0 m Connector Cable Height Adjuster Holes LED lights Battery CoverMask Clip Speaker iPod Control Buttons Cam Knob Depth Rating 300ft / 90m Cam Knob Lock Instructions QuickstartIII.Install batteries 3 AA V. Install iPod VI. Turn on iPod Cleaning & Storing the O-ring ReplacementPrior to use verify Do NOT use if To Close Case IV. Install batteries Insert and height adjuster reference Included insert and height adjustersHeight Adjuster Height Adjuster iPod Authentication Power On/OffVI. Insert iPod VII. Operation In case of a Steady Red LED IX. General Storage ProceduresIn case of a Flashing Red LED Mode Button XII. General Use Notice X. Contact Us XIII. Warranty Coverage To Obtain Service FAQ’sCustomer Support Hours and Contact Information XVI. ReturnsPage w w w . H 2 O A u d i o . c o m

H2O Audio iDV1-75, iDV1-5A1 manual

Models: iDV1-75 iDV1-5A1

Notes: