Onkyo HTP-103E instruction manual Precaution on use, Troubleshooting, Specifications, Placement

Precaution on use

■Placement

•The enclosure is made of wood and therefore sensitive to extreme temperatures and humidity. Avoid placing the unit in locations subjected to direct sunlight or in humid places such as near an air conditioner, humidifier, a bathroom or kitchen. If you do so, damage may occur.

•Keep water and other liquids away from the unit. If water is spilled into the unit, not only the unit but also the connected receiver may be damaged.

•Place the unit on a level and rigid surface free from vibration.

•This unit is designed to be used in the upright vertical position only. Do not use it in the horizontal or tilted position.

•If the unit is used near a turntable or CD player, howling or skipping of sound may occur. To prevent this, move the unit away from the turntable or CD player or otherwise lower the unit’s output level.

Note:

Abnormal sound can be produced when bass-range signals are excessively boosted by using the receiver’s tone controls or a graphic equalizer, or when a source has the bass range abnormally boosted and is played. Rattling occurs when the signal is beyond the driver’s reproduction capacity. Although it is not a sign of damage, decrease the speaker output level to prevent damage to the driver.

Troubleshooting

Symptom	Cause	Remedy
The unit does not turn on	• The power plug is not fully inserted.	• Insert the power plug fully into the
		power outlet.
No sound output	• The OUTPUT LEVEL knob is set to the	• Set the OUTPUT LEVEL knob
	MIN level.	properly.
	• Pin-connector cable is disconnected at the	• Connect the cable to the LINE
	LINE INPUT jack.	INPUT jack.
	• The input signal is so small that the unit	• Increase the subwoofer output level
	entered the standby state.	of the receiver slightly.
Hum noise	• Pin-connector is not inserted completely.	• Fully insert the pin-connector.
	• External leakage flux (induction noise by	• Set the unit away from the noise
	TV, etc.) occurs.	source.

Specifications

Type	Bass-reflex with built-in power amplifier
Frequency response	30 Hz-150 Hz
Output power	150 W Dynamic
Input sensitivity	220 mV
Input impedance	15 kΩ
Woofer	200 mm cone type
Power supply	AC 230-240 V, 50 Hz
Power consumption	77 W
Dimensions (W×H×D)	235 × 518 × 411 mm
Weight	12.6 kg

Specifications and appearance are subject to change for improvement without prior notice.

5