Onkyo HTP-103E instruction manual Connection, Precaution on use, Placement, Use with a TV set

SKF-103F / SKC-103C / SKM-103S / SKB-103 Speaker system

Connection

•Be sure to turn off your receiver before connecting the speaker system. Connecting it while the receiver is on may result in damage to the receiver or the speaker system.

•The speaker cables and speaker terminals are color-coded to facilitate connection. Connect each cable to the matching-colored terminal.

•Be sure to connect the speaker’s positive (+) and negative (–) input terminals with the receiver’s corresponding positive and negative speaker terminals. Otherwise, undesirable sound field or impaired bass-range reproduction will result.

•Before turning on the receiver’s power switch, pull lightly on the speaker cables to ensure that they are connected securely.

Precaution on use

This speaker system can handle the specified input power when it is used for ordinary music reproduction. If the following abnormal signals are fed to the speaker, however, an overcurrent may flow in the internal circuits, causing burning or breakage of the wires even if the input power is below the specified rating.

1.Noise produced when FM station is not tuned in

2.Sound produced when fast-forwarding cassette tape deck

3.High-frequency sound generated by an oscillator, an electronic musical instrument, etc.

4.Oscillating receiver signals

5.Special test signals produced by audio checking CD, etc.

6.Sound produced when connecting or disconnecting audio connection cables (always turn off the receiver’s power before connecting or disconnecting cables).

7.Howling when a microphone is used

■Placement

SKF-103F Front speakers

Place the front speakers in similar places to the right and left of the listening area. Angle the speakers towards the listener to enhance the stereo effect. If they are placed in extremely different positions, left and right channel balance will be adversely affected.

SKC-103C Center speaker

Place the SKC-103C as close as possible to your television set, for example, above or below the television set. Tilt the speaker upward or downward so that it is directly facing the listener.

Be sure to set the SKC-103C firmly on the television set or other equipment so that it cannot slip and fall. This is especially important if you have small children.

SKM-103S Surround speakers

Place the surround speakers 1 m above the listener’s ear level, either directly to the side of the listening area or else slightly behind the listening area. Adjust the angles so that these speakers are facing directly towards the listeners.

If the speakers are to be wall-mounted, make sure that the walls are strong enough to support the speaker’s weight. The weight that mounting screws can support varies greatly depending on the wall material and the position of the wall studs. Use the thickest and longest possible mounting screws with mounting screw head diameters less than 6.3 mm and shank diameters less than 3.5 mm (please consult with your interior designer or contractor).

SKB-103 Surround back speaker

Place the surround back speaker 1 m above the listener’s ear level and just at the back of the listener. Adjust the angle so that this speaker is facing directly towards the listeners.

If the speaker is to be wall-mounted, make sure that the wall is strong enough to support the speaker’s weight. The weight that mounting screws can support varies greatly depending on the wall material and the position of the wall studs. Use the thickest and longest possible mounting screws with mounting screw head diameters less than 6.3 mm and shank diameters less than 3.5 mm (please consult with your interior designer or contractor).

■Use with a TV set

In general, Braun tubes used for color television sets are extremely sensitive and can be affected even by the magnetism of the earth. If a speaker system is used near them, discoloration or distortion of pictures will occur. To allow use with color television sets, etc., the SKF-103F Front speakers and SKC-103C Center speaker are provided with magnetic shielding. Even so, discoloration may still occur, depending on the installation environment. If discoloration occurs, turn off the television set, wait 15 to 30 minutes, and then turn it on again. This activates the self-demagnetizing function of the television set.

If discoloration persists even after performing this remedy, move the speaker further from the television set. Discoloration may also occur when a magnet or other magnetized object is near the television because of the combined effect.

6