Control positions and names, Connection, Adjustment

SKW-150XPowered subwoofer

Control positions and names

■Rear Panel

	POWERED SUBWOOFER
	MODEL NO. SKW-150X
OUTPUT
OUTPUT	LINE
LEVEL	INPUT

MIN

MAX

1 POWER switch and indicator

To turn on the SKW-150X, set the POWER switch to the ON position (the indicator lights up).

To turn off the SKW-150X, set the POWER switch to the OFF position (the indicator goes out).

Red: The unit is in standby mode

Green: The unit is in operation mode

RED : STANDBY

GREEN : ON

POWER

The SKW-150X automatically turns to STANDBY mode when no signal has been input for about 20 minutes. The

ONOFF

To AC outlet

SKW-150X automatically enters operation mode when a signal is input during STANDBY mode.

2 OUTPUT LEVEL knob

Use this knob to adjust the output level of the subwoofer.

3 LINE INPUT jack

Connect this jack to the subwoofer pre-out of the receiver.

Note:

The auto standby function operates on the existence or absence of a constant level input signal. If the auto standby function does not operate properly, try slightly increasing (or decreasing) the subwoofer output level of the receiver.

Connection

For safety reasons, be sure to unplug the power cord of this unit and turn the power off for all other system components before connecting or disconnecting any components.

■Connection to receiver

•Connect the SKW-150X subwoofer to the SUBWOOFER PREOUT jack on your receiver.

■Power cord

•Make sure that all connections other than the power cord for the system have already been made.

•Turning on the power for the system may cause a very brief current surge that might affect other devices such as a computer, if both products are on the same circuit. Connect those devices to another AC outlet.

Adjustment

■Output level

•Adjust the SKW-150X output level properly for your listening room and connected speakers.

•Note that you may possibly set the subwoofer at high output levels because super bass-range sound is not as audible as sound in other ranges. To obtain well-balanced frequency characteristics, set the output level to a slightly lower level than seems optimal (this will also prevent the input of overpowering signals).