Haan TS-30 user manual Operating Instructions, Quick Release Tab, Out Water Reservoir Stopper Tab

Using Your QuickPro™ Portable Steamer & Sanitizer

Fig 1

Quick-

Release

Tab

Fig 2

Hold and pull

out

Fig 3

Water

Reservoir

Stopper

Tab

Fig 4

Water

Reservoir

Stopper

Operating Instructions:

1)Remove all parts from the packaging.

2)Set the HAAN® QuickPro™ on the Metal Resting Tray. Do not plug the unit in while adding water to the reservoir.

3)Remove the Water Reservoir by pressing the Quick-Release Tabs (Fig 1) on both sides of the appliance. Hold them in as you pull the Water Reservoir out of the rear of the appliance main body (Fig 2).

NOTE: The HAAN® QuickPro™ has been designed to operate using untreated tap water. If the water being used is very hard (check with your local water authority) it could leave mineral deposits inside the appliance that can build-up over time and interfere with the function of the unit. Is possible to mix the tap water with distilled water in the following proportions to help reduce mineral build-up within the appliance and prolong the lifespan of your Portable Steamer & Sanitizer.

•50% untreated tap water with 50% distilled or demineralized bottled water

4)Once removed from the main body, turn the Water Reservoir up to show the grey stopper. (Fig 3)

5)Grasp the tab on the stopper and gently pull the stopper out (Fig 4). Remove it only enough to allow for adding water. DO NOT break the connecting elastic band.

6)Add water to the reservoir thru the stopper hole until the reservoir is full. Do not overfill. Carefully replace the stopper and close it securely aligning the tab as shown (Fig. 3).

7)Replace the Water Reservoir into the main body of the appliance. With the Quick-Release tabs at the inner bottom, slide the Water Reservoir in until the tabs clip securely (Fig 1).r

w w w. H A A N USA . com 877 - HAAN DIRECT / 877 - 422 - 6347 pg 7