Installation and adjustment
Please install and adjust the machine according to the requirement of the mannual. It is very important to your security and correct operating the machine.
The soak procedure can work in cooperation with automatic programs like standard, carpeting fiber.There is intermittent pulsator stirring during soak.
After the machine starts operation, you can only set the program and procedure during washing,
Install the inner cover
1.Open the top lid of the washing machine.
2.Put the inner cover component on the outer tub cover, aiming the inner cover shaft to the installation hole of the corresponding outer tub cover shaft groove.
3.Firstly insert the inner cover shaft of one side into the corresponding outer tub cover shaft groove, then push the another inner cover shaft into the corresponding outer tub cover shaft groove. Please install to designated position to guarantee there are no dropping or abnormal sound in opening and closing of the inner cover, and the operation shall be smooth. Do not dismount the inner cover component after washing.
Outer tube cover
Outer tube cover shaft groove
Inner cover shaft
Damping cushion
Inner cover components
Section • enlarging
Push
and can not make setting in other cases.
The function of | Softener | will be chosen at the same time as sterilize is selected ,when the |
sterilize is not chosen | ,there will be no water flowing into the box for thesoftener preparation. | |
So do not add softener preparation into the box to aviod wasting
If the water pressure is too low,in order to wash the closes cleanly,the machine will change from " saving water "to "storing water "automatically.
4 Push the " water level "button,select suitable water level
After switching on the power, the washing machine will execute fuzzy program automatically to detect the cloth. After defection, it can set the water level automatically. To select other water level, first push the "start/pause" button, then push the "water level" button to set the water level.
5. Push the
Install the bottom plate
After you open the package, please lean the washing machine gently down on soft items ( like the towel cloth, blanket, etc. ). Install the bottom plate to the bottom of the machine, then lift the machine up gently. See to the figure:
Back
Front |
Soft items
Bottom plate
6 Push the "reserve" button to select suitable | Reserve |
reserve wash program |
|
After switching on the power, the reserve program is set to off mode automatically. If you need to set the washingprocedure to be finished at reserved time, please push the " reserve " button to set the reserve wash program. Refer to reserve button in Page 11 for selection.
Confirm the operation of reserve program
Adjust the Installation position
The distance that washing machine away from wall should be above 20mm. The largest allowed slope of the shank base of the machine is 2 
. The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods:
When the "reserve" function is activated, the indicator light of the program you have set will be off. The "reserve (hour)" and "time remain" indicator lights will be on. During reserve procedure, push the "reserve" button to display the reserve mode.
To change the running program or cancel the reserve setting, you need to switch off the power and make new selection.
Confirm it's horizontal:
Hang the lead line to check if it is horizontal.
Adjust the adjustable leg:
1 .To twist the adjustable leg, please first lift up the side of the leg slightly, loosen the adjustable nut, and twist the leg.
2 . After adjustment, fasten the nut.
Loosen
High
the adjustable nut
Fasten
the adjustable feet
Low
7 Push the "Start/Pause" button
6 Finish washing
After finishing wash 
it'll alarm automatically
