Freezer Installation
1)The freezer is designed for
2)The freezer should not be recessed or built in.
3)Install the freezer on a base strong enough to support it when fully loaded. Ensure the freezer is on a stable surface to minimise noise and vibration.
4)Install the handle: you can find the handle in the foodbasket,and loosen the screws of the door, install the handle on the door,then tighten the screws, in the end , clock the handle lid in the handle.
5)When moving the freezer, never tilt at an angle more than 45o as this could damage the compressor and freezer system. If the freezer is tilted over 45o, or has been stored on its side, allow the freezer to stand upright for at least 24 hours prior to plugging it back in. This will allow the refrigerant to settle.
6)Install the freezer in a
7)Install the freezer in a dry place to prevent rust from forming on the compartment body and to avoid the risk of damaging the electric insulation.
Electrical Connection and Precautions
1)IMPORTANT – For personal safety, this appliance must be properly earthed.
2)The voltage range for this appliance is 187v – 242v. In the event that your regional power supplier cannot meet this requirement, please use a safe and reliable automatic voltage regulator with a minimum output of 500W to avoid damaging the compressor.
3)A 13 Amp, 3 pin plug and 5 Amp fuse only must be used for this freezer to avoid serious damage. The plug should always be wired in accordance with the following codes:
Green and Yellow | EARTH (E) |
Blue or Black | Neutral (N) |
Brown or Red | LIVE (L) |
It is safest to consult a qualified electrician at all times
4)In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electrical current. This appliance is
12
