End of programme
Six beeps will indicate that the wash cycle has finished and all the programme indicators light.
Switching the dishwasher OFF
Several minutes after the programme has ended:
Set main switch “A” to OFF.
Open the door .
Turn the water tap off.
Remove dishes, etc. when they have cooled down.
Interrupping the programme
Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times every thirty seconds.
If the appliance has already heated up or the hot water was switched ON and then the appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may open due to expansion.
Delayed start programming
You can delay the start of a programme in increments of one hour up to 12 hours.
Switch dishwasher ON. |
|
Immediately press the Delayed Start button | “D ”, the delayed start indicator “E ” blinks, the delayed |
start time indicator “F ” changes to “ | ”. |
Press the Delayed Start button “D ” as many times as necessary until the numerical display shows the required delay.
To cancel the time delay setting, pressing the Delayed Start button until the delayed start indicator “E” goes out.
Press programme button “ I ” to choose the desired programme.
E |
|
|
D | F | I |
|
|
16
